Ptx1000 Physical Specifications; Site Electrical Wiring Guidelines; Table 19: Physical Specifications For The Ptx1000; Table 20: Site Electrical Wiring Guidelines - Juniper PTX1000 Hardware Manual

Packet transport router
Hide thumbs Also See for PTX1000:
Table of Contents

Advertisement

PTX1000 Packet Transport Router Hardware Guide

PTX1000 Physical Specifications

Table 19: Physical Specifications for the PTX1000

Description
AC-powered chassis
DC-powered chassis

Site Electrical Wiring Guidelines

Table 20: Site Electrical Wiring Guidelines

Site Wiring Factor
Signaling limitations
Radio frequency
interference
50
You must leave at least 24 in. (61 cm) both in front of and behind the PTX1000 for
service personnel to remove and install hardware components, you must leave adequate
space at the front and back of the PTX1000. NEBS GR-63 recommends that you allow
at least 30 in. (76.2 cm) in front of the rack or cabinet and 24 in. (61 cm) behind the
rack.
Table 19 on page 50
lists the physical specifications for the PTX1000 chassis.
Weight
With field-replaceable units (FRUs)
installed: 68.6 lb (31.1 kg)
With FRUs installed: 67.8 lb (30.8 kg)
Table 20 on page 50
describes the factors you must consider while planning the electrical
wiring at your site.
WARNING:
It is particularly important to provide a properly grounded and
shielded environment and to use electrical surge-suppression devices.
Guidelines
If your site experiences any of the following problems, consult experts in electrical surge
suppression and shielding:
Improperly installed wires cause radio frequency interference (RFI).
Damage from lightning strikes occurs when wires exceed recommended distances or pass
between buildings.
Electromagnetic pulses (EMPs) caused by lightning damage unshielded conductors and
electronic devices.
To reduce or eliminate RFI from your site wiring, do the following:
Use a twisted-pair cable with a good distribution of grounding conductors.
If you must exceed the recommended distances, use a high-quality twisted-pair cable with
one ground conductor for each data signal when applicable.
Height
Width
3.46 in.
17.35 in.
(8.8 cm)
(44.07 cm)
Copyright © 2018, Juniper Networks, Inc.
Depth
31 in. (78.7 cm)
without handles for
fans or power
supplies.

Advertisement

Table of Contents
loading

Table of Contents