Power Cord Retainer Installed On The Ac Power Supply Module - Juniper MX204 Hardware Manual

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
Figure 36: Power Cord Retainer Installed on the AC Power Supply Module
1
2
3
1— Input status LED
2— Output status LED
3—Fault LED
Press the small tab on the retainer strip to loosen the loop. Slide the loop until you
6.
have enough space to insert the power cord coupler into the inlet.
Insert the power cord coupler firmly into the inlet.
7.
Slide the loop toward the power supply until it is snug against the base of the coupler.
8.
Press the tab on the loop and draw out the loop into a tight circle (see
9.
Figure 37 on page 75).
Route the power cord appropriately. Verify that the power cord does not block the air
10.
exhaust and access to router components, or drape where people could trip on it.
Power on the power supply at source.
11.
Repeat Step 1 through Step
12.
Figure 37: Connecting AC Power to the Router
Tools and Parts Required for MX204 Router Grounding and Power Connections on
page 71
Chapter 13: Connecting the Router to Power
4
5
4— AC power cord retainer installed
5— Ejector lever
10 for the installing the remaining power supply.
75