Disconnecting A Fiber-Optic Cable From The Ptx1000; Figure 42: Installing A Transceiver In The Ptx1000 - Juniper PTX1000 Hardware Manual

PTX1000 Packet Transport Router Hardware Guide

Disconnecting a Fiber-Optic Cable from the PTX1000

96
CAUTION: Before you slide the transceiver into the port, ensure that the
transceiver is aligned correctly. Misalignment might cause the pins to
bend, making the transceiver unusable.
Slide the transceiver in gently until it is fully seated (see
5.
Remove the rubber safety cap when you are ready to connect a cable to the transceiver.
6.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.

Figure 42: Installing a Transceiver in the PTX1000

The PTX1000 has optical transceivers to which you can connect fiber-optic cables.
Before you disconnect a fiber-optic cable from a PTX1000, ensure that you have taken
the necessary precautions for safe handling of lasers (see
Apertures Warning" on page 125
page 126).
Ensure that you have the following parts and tools available:
Rubber safety cap to cover the transceiver
Rubber safety cap to cover the fiber-optic cable connector
and "Laser and LED Safety Guidelines and Warnings" on
Copyright © 2018, Juniper Networks, Inc.
Figure 42 on page 96).
"Radiation from Open Port