Commissioning
5.4 Quick commissioning with a PC
6. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
Image 5-5
Image 5-6
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
7. Proceed as follows:
You have transferred an inverter accessible via the USB interface into your project.
92
Inverters found in STARTER
Inverters found in Startdrive
With STARTER
Select the inverter ☑.
•
Press the "Accept" button.
•
With Startdrive
Transfer the inverter into the project using the menu:
"Online - Upload device as new station (hardware and
software)".
Operating Instructions, 07/2016, FW V4.7 SP6, A5E34262100B AD
Converter with control units CU240D-2