Definable Contents Of Programmable Input Ports 1-7 - Smartgen HGM4020DC User Manual

7.3 DEFINABLE CONTENTS OF PROGRAMMABLE INPUT PORTS 1-7

Table 12 - Definable Contents of Programmable Inputs 1~7(Ground connected (B-) is active.)
No. Items
0 Not Used
1 Alarm Mute
2 Reset Alarm
3 Emergency Stop
4 High Temp Shutdown
5 Low OP Shutdown
6 Fuel Level Warn
7 Warn Input
8 Shutdown Input
9 Remote Start Onload
10 Remote Start Offload
11 Reset Maint. Time
12 Panel Lock
13 Inhibit Timing Start
14 Inhibit Auto Start
15 Remote Control
16 Charge Alt Fail IN
17 Low Oil Level Warn
18 Manual/Auto Switch
19 Reserved
20 Idle Input
21 Reserved
22 Control At Gate
23 Aux. Mains Fail
24 Aux. Mains OK
25 Pile Under Volt
26 Reserved
27 Reserved
28 Reserved
29 Reserved
30 Reserved
31 Reserved
HGM4020DC Genset Controller
HGM4020DC GENSET CONTROLLER USER MANUAL
Input port is inactive.
If input port is active, "audible alarm" output will be inhibited.
If input port is active, shutdown alarms and ELE trip alarms can be
reset.
If input port is active, genset will alarm shutdown immediately.
After safety on delay is expired, if this input is active, genset will alarm
shutdown immediately.
After safety on delay is expired, if this input is active, genset will alarm
shutdown immediately.
If this input is active, controller will send low fuel level warning alarm
signal.
If this input is active, controller will send external warning alarm
signal.
If this input is active, genset will alarm shutdown immediately.
When this input is active in auto mode, genset starts automatically
and takes on load after normal running. Otherwise, genset will stop
automatically if this input is deactivated.
When this input is active in auto mode, genset starts automatically
and without taking load after normal running. Otherwise, genset will
stop automatically if this input is deactivated.
When this input port is valid, reset the maintenance time countdown,
it is invalid for the maintenance date.
When input is active, all keys expect
display on the right side of fifth line of LCD main page.
When input port is active in auto mode, genset scheduled run is
inhibited.
When input port is active in auto mode, genset auto start is inhibited.
When the input is active, keys on the panel are locked except for
keys and remote mode will display on the LCD. Remote
module pattern and start/stop operation can be switched by keys on
the panel.
When the input is active, controller will send failed to charge warning.
When input port is active, controller will initiate low oil level warning
alarm.
When input is active, it switches to auto mode automatically, panel
buttons and local operation are inactive; When input is inactive, it
switches to manual mode automatically, remote operation is inhibited.
When the input is active, idle speed control starts outputting.
When the input is active, controller will send access control input
warning.
Simulate mains is abnormal.
Simulate mains is normal.
When the input is active, it is considered battery is under voltage. If
crank disconnect conditions are configured, genset will be started in
auto mode.
Version 1.0
Function Description
2019-04-10
are inactive. will
Page 25 of 31