Definable Contents Of Output Ports; Definable Contents Of Input Ports - Smartgen GENSET CONTROLLER MGC310 User Manual

7.2 DEFINABLE CONTENTS OF OUTPUT PORTS

No. Items
0 Not Used
1 Common Alarm
2 ETS Control
3 Idle Speed Control
4 Preheating Control
5 Gen Close Output
6 Mains Close Output Mains close outputs after mains normal delay ends.
7 High Speed Output
8 Fuel Pump Output
9 Reserved

7.3 DEFINABLE CONTENTS OF INPUT PORTS

Table 9 Definable Contents of Input Ports ( GND Connected is active for all)
No. Items
0 Not Used
1 Temp. High Alarm Input
2 Oil Pressure Low Input
3 Reserved
4 Outside Shutdown Input
Cooling Shutdown
5
Temp. High
6 Reserved
7 Reserved
8 Reserved
MGC300 Genset Controller
Table 8 Definable Contents of Output Ports
When this is chosen, output port won't output.
Includes all shutdown alarms and warnings; when there is only warning
alarm input, alarm is not latched; when shutdown alarms occur, alarms are
latched until they are reset;
It is used for some gensets with stop electromagnet. Pull-in occurs when
"stop idle speed" ends. Open occurs when "ETS Delay" ends.
It is used for engines with idling speed. Pull-in occurs when the engine
starts. Open occurs when it enters "Warming-up". Pull-in occurs in the
stopping process of idling speed and open occurs when the genset stops
completely.
Close before start, open before energization.
Generator close outputs when generator is normally running.
Outputs when enters warming up time; disconnects after cooling;
Outputs when fuel pump works;
After safety on delay is finished, generator shutdown alarm occurs
immediately if this signal is active.
If this signal is active, genset will immediately shutdown;
When this signal is active and genset is running normally, if Temp.
for
high occurs, controller will stop after cooling delay; when this signal
is inactive, if Temp. high occurs, controller will stop immediately;
Version 1.1
MGC300 Genset Controller User Manual
Function Description
Remark
2020-01-04 Page 19 of 27