5.3 TRIP AND STOP ALARMS
When controller detects trip and stop alarms, it will immediately control rectifiers to stop outputting, and
stop the genset after cooling time.
No.
Type
Over Current ELE
1
Trip
6
WIREING CONNECTION
HGM4020DC Genset Controller
HGM4020DC GENSET CONTROLLER USER MANUAL
Table 8 – Trip and Stop Alarms
When controller detects the genset current is over than the pre-set value
(delay time is expired) and the action selects "trip and stop", it will send
alarm signals and the corresponding alarm information will be displayed
on LCD.
Fig.2 – Rear Panel Drawing
Version 1.0
Description
2019-04-10
Page 15 of 31