Pre-Installation Requirements; Floor Strength; Environmental Requirements; Transportation Conditions - Planmeca Compact i3 Installation Manual

2 Pre-installation requirements

2.1 Floor strength

2.2 Environmental requirements

2.2.1 Transportation conditions

2.2.2 Storage conditions

Installation manual
CAUTION
Do not connect items which are not specified as part of the system.
CAUTION
Do not connect a Multiple Portable Socket-Outlet or extension cord to the
system.
NOTE
The dealer must check the floor material and strength of the installation site
before the installation.
The floor must be straight within 1%. Antistatic floor materials should be
preferred.
The concrete floor must be 50mm (2in.) thick. The concrete strength must be
type C20/25-C50/60 (According to standard EN 206-1:2000), non-cracked
concrete.
With concrete floor, the unit can be installed without installation plate.
The required attachment hardware depends on the floor material. The
attachment hardware, as well as floor material must endure a pullout force of
5900 N.
The person installing the unit is responsible for using the appropriate
attachment hardware and ensuring the sufficient pullout strength of the floor.
Consult a local structural engineer if necessary,and always follow local
construction regulations.
Accepted limits for unit transportation are the following:
• Temperatures: -20 °C to +60 °C (-4 °F to 140 °F)
• Relative humidity: 5% RH to 95% RH "Absence of condensation"
• Air pressure: 700 hPa to 1060 hPa (10 psi to 15 psi)
Accepted limits for unit storage are the following:
• Temperatures: -5 °C to +60 °C (23 °F to 140 °F)
• Relative humidity: 5% RH to 95% RH "Absence of condensation"
• Air pressure: 700 hPa to 1060 hPa (10 psi to 15 psi)
NOTE
If the unit has been stored at temperatures below +10 °C (50 °F) for more
than few hours, time must be allowed for the unit to reach the room
temperature in its own package, before connecting the dental unit to mains
voltage.
2 Pre-installation requirements
Planmeca Compact i3 3