Installing The Media Converter Slide-In-Modules - Transition Networks PointSystem CPSMC1810-200 User Manual

2.1.3

Installing the Media Converter Slide-in-Modules

CAUTION:
precautions when installing the media converter slide-in-module(s) into the chassis.
Failure to observe this caution could result in damage to, and subsequent failure of,
the media converter slide-in-module(s).
NOTE: The media converter slide-in-modules can be installed in any installation
slot, in any order.
To install the media converter slide-in-module into the CPSMC18xx-xxx chassis:
1. If a chassis face plate is covering the installation slot, remove the face plate from
2. Align the slide-in-module with the chassis installation slot so that the panel
3. Carefully slide the slide-in-module into the installation slot, while aligning the
4. Push in and rotate the attached panel fastener screw clockwise to secure the
5. Repeat steps 1 through 4 for any additional media converter slide-in-module(s).
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Wear a grounding device and observe electrostatic discharge
the installation slot by removing the one (1) screw that secures the plate to the
front of the chassis.
NOTE: If the slide-in-module requires two slots, remove the face plates from
two (2) adjacent installation slots.
fastener screw is at the top of the module.
Media
Conversion
Center
PWR PWR
TX PWR
PWR LKS LKS
LKF
Power
1
RXF LKM LKM
In Use
RX LNK RXC LKC
TX TX
TX
Power
2 RESET
In Use
ESD
RX
RX
Gnd.
RX
TX TX
Term.
RX RX
CPSMC1800 CPSMC1800
module's circuit board with the installation guides.
NOTE: Ensure that the slide-in-module is firmly seated inside the chassis.
module to the chassis.
CPSMC18xx-xxx PointSystem ™ Chassis
PWR PWR
PWR PWR
LA LKS SPD PWR LKS LA
LNK LNK
RXF LKM FRX FLNK LKM RXF
RXC COL CRX CLNK RXC COL
TX TX
Link Alert Link Alert
E D
E D
TX
PWR
LKF
RXF
RX RX
RXC TX LKC TX
RX
TX
0 50½ 0 50½
RX RX
RX
Panel Fastener Screw
CETTF100
PWR
LKS SPD PWR
LKM FRX FLNK
CRX CLNK
TX
TX
RX
RX
TX
RX
9