Replacing The Media Converter Slide-In-Modules - Transition Networks PointSystem CPSMC1810-200 User Manual

2.1.4

Replacing the Media Converter Slide-in-Modules

CAUTION:
precautions when replacing media converter slide-in-module(s). Failure to observe
this caution could result in damage to, and subsequent failure of, the media
converter slide-in-module(s).
NOTE: The media converter slide-in-modules can be hot-swapped.
To replace a media converter slide-in-module in the CPSMC18xx-xxx chassis:
1. Remove the slide-in-module to be replaced by loosening the panel fastener
2. Align the replacement slide-in-module with the chassis installation slot so that
3. Carefully slide the replacement slide-in-module into the installation slot, while
4. Push in and rotate the attached panel fastener screw clockwise to secure the
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Wear a grounding device and observe electrostatic discharge
screw that secures the module to the chassis front. Slide the module from the
chassis.
the panel fastener screw is at the top.
Media
Conversion
Center
PWR PWR
TX PWR
PWR LKS LKS
LKF
Power
1
RXF LKM LKM
In Use
RX LNK RXC LKC
TX
TX
Power TX
2
RESET
In Use
ESD
RX RX
Gnd.
RX
TX TX
Term.
RX RX
CPSMC1800 CPSMC1800
aligning the module's circuit board with the installation guides.
NOTE: Ensure that the slide-in-module is firmly seated inside the chassis.
module to the chassis.
CPSMC18xx-xxx PointSystem ™ Chassis
PWR PWR
PWR PWR
LA LKS SPD PWR LKS LA
LNK LNK
RXF LKM FRX FLNK LKM RXF
CRX CLNK
RXC COL RXC COL
TX TX
Link Alert Link Alert
E D E D
TX
PWR
LKF
RXF
RX RX
RXC LKC
TX RX TX
TX
0 50½ 0 50½
RX RX
RX
Panel Fastener Screw
CETTF100
PWR
LKS SPD PWR
LKM FRX FLNK
CRX CLNK
TX
TX
RX
RX
TX
RX
10