Advertisement
E-MCR-04 Media Converter Rack
User's Guide
Transition Networks E-MCR-04 series media converter rack provides space and
power in a rack-mountable chassis for twelve (12) separate and independent
Transition Networks stand-alone media converters, each with power requirements
of 12 VDC.
NOTE: The E-MCR-04 media converter rack is intended for the installation of
media converters designed and built only by Transition Networks.
Part Number
Description
E-MCR-04
Provides installation space for up to twelve (12) Transition
Networks stand-alone media converters that require an
external power supply and with dimensions approximately
3.0 in. high x 1.0 in. wide x 4.7 in. deep (76 mm x 25 mm x
119 mm).
Installation . . . . . . . . . . . . . . . . . .2
Maintenance . . . . . . . . . . . . . . . .6
Technical Specifications . . . . . . . .7
Compliance Information . . . . . . . .8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Transition Networks E-MCR-04
Summary of Contents for Transition Networks E-MCR-04
- Page 1 E-MCR-04 Media Converter Rack User’s Guide Transition Networks E-MCR-04 series media converter rack provides space and power in a rack-mountable chassis for twelve (12) separate and independent Transition Networks stand-alone media converters, each with power requirements of 12 VDC. NOTE: The E-MCR-04 media converter rack is intended for the installation of media converters designed and built only by Transition Networks.
-
Page 2: Installation
E-MCR-04 Installation Installation -- Continued Attach the E-MCR-04 to the Site Rack Table-Top Installation Locate four (4) screws (provided) and optional clip-nuts (not provided) The E-MCR-04 is shipped with nine (9) rubber feet for optional installation on for each E-MCR-04 Media Converter Rack to be installed. a table or other flat, stable surface in a well-ventilated area. - Page 3 E-MCR-04 Installation Connect the Media Converter(s) to Power -- Continued 11. Locate the media converter power cord (shipped with its connector Install the Media Cables secured in a rubber grommet located above the media converter installation slot). CAUTION: Do not use the Media Converter Rack chassis to provide earth ground for any 10BASE-2 cable shield connected to any installed media 12.
-
Page 4: Maintenance
E-MCR-04 Maintenance Technical Specifications Replace the Fuse For use with Transition Networks Model E-MCR-04 or equivalent. Standards: UL listed, FCC & CISPR Class A; CE Mark Set the On/Off switch to “0”. Dimensions: 17.0" x 15.0" x 5.0" (432 mm x 381 mm x 127 mm) Remove the power cord from the AC wall socket. - Page 5 Compliance Information -- Continued Canadian Regulations This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications. Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la Class A prescrites dans le Règlement sur le brouillage radioélectrique édicté...
Need help?
Do you have a question about the E-MCR-04 and is the answer not in the manual?
Questions and answers