Configure Dhcpv4 Global Relay Port - ZyXEL Communications XGS4600 Series User Manual

Table 233 IP Application > DHCP > DHCPv4 > Global (continued)
LABEL
Apply
Cancel

54.4.4 Configure DHCPv4 Global Relay Port

Use this screen to apply a different DHCP option 82 profile to certain ports on the Switch. To open this
screen, click IP Application > DHCP > DHCPv4 > Global > Port.
Figure 391 IP Application > DHCP > DHCPv4 > Global > Port
The following table describes the labels in this screen.
Table 234 IP Application > DHCP > DHCPv4 > Global > Port
LABEL
Port
Option 82 Profile
Add
Cancel
Clear
Index
Port
Chapter 54 DHCP
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Enter the number of ports to which you want to apply the specified DHCP option 82 profile.
You can enter multiple ports separated by (no space) comma (,) or hyphen (–) for a range. For
example, enter "3–5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
In stacking mode, the first number represents the slot and the second the port number. Enter 1/
1–1/24,2/28 for ports 1 to 24 for the Switch in slot 1 and port 28 for the Switch in slot 2, for
example.
Select a pre-defined DHCP option 82 profile that the Switch applies to the specified ports. The
Switch adds the Circuit ID sub-option and/or Remote ID sub-option specified in the profile to
DHCP requests that it relays to a DHCP server.
The profile you select here has priority over the one you select in the DHCP > DHCPv4 > Global
screen.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Click this to reset the values above based on the last selected entry or, if not applicable, to clear
the fields above.
Click Clear to reset the fields to the factory defaults.
This field displays a sequential number for each entry. Click an index number to change the
settings.
This field displays the port(s) to which the Switch applies the settings. In stacking mode, the first
number represents the slot and the second the port number.
XGS4600 Series User's Guide
489