Board Configuration (Expansion I/O Board); Confirmation With Epson Rc+ 7.0 (Expansion I/O Board) - Epson RC700 Series Original Instructions Manual

16.2.2 Board Configuration (Expansion I/O Board)

Board Appearance
CN3
DSW1

16.2.3 Confirmation with EPSON RC+ 7.0 (Expansion I/O Board)

When an expansion I/O board is mounted to the option unit, the Controller software
automatically identifies the expansion I/O board. Therefore, no software configuration is
needed.
Correct identification can be confirmed from EPSON RC+ 7.0.
(1) Select the EPSON RC+ 7.0 menu-[Setup]-[System Configuration] to display the
(2) Select [Controller]-[Inputs / Outputs].
(3) Make sure that "Yes" is displayed in the Installed column.
RC700 Series Rev.3
Switch and Jumper Configuration
Setup the DSW1 and DSW2. CN3 is all open.
1 st board
SW1
SW2
SW3
SW4
SW5
SW6
SW7
DSW2
SW8
SW1
SW2
SW3
SW4
[System Configuration] dialog.
The expansion I/O board is identified by the Controller software. Corresponding Input
and Output is available.
Functions 16. Option Slots
3 board
rd
2 nd board
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
SW1
SW2
SW3
SW4
4 board
th
SW8 SW8
SW7 SW7
SW6 SW6
SW5 SW5
SW4 SW4
SW3 SW3
SW2 SW2
SW1 SW1
SW4 SW4
SW3 SW3
SW2 SW2
SW1 SW1
167