Installation - Epson RC700 Series Original Instructions Manual

Installation 2. Installation

2.5.2 Installation

Install the Control unit and Drive unit on a flat surface such as wall, floor, and Controller
box in the direction shown in (A) to (C).
(A) Flat mounting
(B) Upright mounting
(C) Rack mounting
NOTE For Control Unit and Drive Unit installation to the Controller box or the base table, process

screw hole drilling as follows.
28
* The rubber foot needs to be
replaced.
Attach the rubber foot with the flat
side facing the controller.
The size of the screw that secure the
rubber foot is M4×8.
When replacing the rubber foot, be
careful not to lose the screw. Also, do
not use a screw of size other than
M4×8.
* A plate for rack mounting is required.
RC700 Series Rev.3
(Figure: RC700)