Epson RC700 Series Original Instructions Manual page 104

Functions 2. Part Names and Functions
(16) RC700DU: DU OUT Connector / RC700DU-A: OUT Connector
(17) Development PC connection USB port
(18) Memory port
(19) Trigger Switch
(20) LAN (Ethernet communication) port
(21) I/O connector
(22) AC IN
(23) Control Unit Signature label
86
The connector for Drive Unit.
This port connects the Controller and the Development PC using a USB cable. Do
not connect other devices except the Development PC.
For details, refer to 7. Development PC Connection USB Port.
This port connects the common USB memory for Controller backup function. Do not
connect other USB devices except the USB memory.
For details, refer to 8. Memory Port.
This switch is for Controller backup function using the USB memory.
For details, refer to 8. Memory Port.
This port connects the Controller and the Development PC using an Ethernet cable.
100BASE-TX / 10BASE-T communication is available.
For details, refer to 9. LAN (Ethernet communication) Port.
This connector is used for input/output device. There are 24 inputs and 16 outputs.
For details, refer to Setup & Operation 13. I/O Connector.
The connector for 200VAC power input.
For details, refer to 3.3.2 AC Power Cable.
The serial number of the Control Unit and other information are shown.
RC700 Series Rev.3