Appliance Height In Framing; Appliance Depth In Framing - Valor H6 Installation Manual

Planning

Appliance Height in Framing

Hearth considerations
• Only a non-combustible hearth can be installed in
front of the appliance if within 4" of the bottom of the
appliance.
• The top surface of the non-combustible hearth must
be at the same level as appliance bottom panel when
using certain trims and accessories—see pages
14-16.
• The non-combustible hearth in front of the appliance,
if within 4" of the bottom of the appliance, must in-
clude the 1/2" Micore insulation board provided to be
used as thermal break between non-combustible and
combustible material underneath.

Appliance Depth in Framing

• 1430 Fixed Framing Kit and 1430CIK Clean Install Kit
install at framing stage and the appliance position is
fi xed in the framing. In both cases, the wall fi nishes
butt up to the frame of the kit.
• All other trims install after the wall fi nish is applied.
The perimeter of the trims overlap the wall fi nish;
therefore the thickness of any wall fi nish materials
must be taken into consideration. The trims have
enough adjustability to allow up to 3/4" thick material
applied over top of the 1/2" thick non-combustible
board. Otherwise the appliance position within the
framing must be adjusted to allow the additional
thickness—see page 25.
Framing
19