Dimensions & Location - Valor H6 Installation Manual

Dimensions & Location
Dimensions
Optional HeatShift
System outlets
[175 mm]
Zero Clearance
5-1/4"
1-3/8"
Electrical Electrical
Inlet Point Access Plate
Left Side View
Location
8
43-7/8" [1115 mm]
42-1/4" [1074 mm]
27-3/8" [696 mm]
TM
2-5/8"
[67 mm]
6-7/8"
36-1/8" [918 mm]
Electrical
Junction Box
Location
Front View
Center
Line
Top View
Face of
Framing
Corner dimensions may be
affected when using
HeatShift. See Appendix D -
HeatShift System on page 82.
Corner Dimensions
Note: This dimension is for the
1430FFK Fixed Framing Kit and
1430CIK Clean Install Kit only.
For all other trims this is the maximum
required and may be reduced if placing
the unit forward of the framing to
accomodate thickness of non-combustible
material over top of non-combustible board.
Header
6-1/8"
1-5/8 8 "
Gas Line
Access Point
Right Side View
Zero Clearance to Stand-offs an
at Back and Sides
1/2"
(12.7 mm)
Heat shield
required when
using rear facing
6-5/8" dia.
Venting
convertible
from top to
rear facing
Center of vent
12-3/4"
(324 mm)