Installation; Appliance Into Framing - Valor HORIZON 534JN Installation Manual

Installation

Install Appliance Into Framing
1. Place the heater in position in the framing.
2. Secure the side support angles to the side studding
through two holes each side with the woodscrews
supplied. The top support angle should abut the
wall fi nish but is not fi xed to the framing.
3. Check the wall fi nish requirements with the home-
owner. If necessary, adjust the position of the heater
so that the distance from the front of the heater
case to the angles is suitable for the thickness of the
wall fi nish (e.g. tile, etc.).
Side angle
adjustment
from inside
firebox
Adjustment for wall
26

Appliance into Framing

NOTE
When adding front and trim, it is important to
install heater flush or slightly recessed into the
finished wall surface. See front/trim installation
for more information.
Top angle
adjustment
from back
of angle
Adjustable for wall finish
material thickness
between 3/8" and 1-3/16"
(10 mm and 30 mm)