Framing; Stud Framing - Valor H6 Installation Manual

Planning

Stud Framing

NOTE
Use of optional HeatShift System affects framing.
See Appendix D - HeatShift System pages 79–98.
1/2" thick non-combustible
board required above appliance
(not supplied) once installed in
framing - see
NOTE: This unit requires a
solid platform to support it.
Combustible framing allowed
between underside
of non-combustible board
and base of heater
page 26
34-1/2"
Between underside of header and
base of heater. Base of heater must
please note that the 1440 4-sided
trim extends 1-1/2" below the base
of heater. Increase cavity height
accordingly.
48" 48"
21" 21"
Any exposed surface directly in front
of the unit which is at a height of
less than 4" from the bottom of
the unit must be non-combustible.

Framing

May be reduced by
thickness of additional
non-combustible
on top of 1/2"
non-combustible
board when using trims
other than 1430FFK
Fixed Framing Kit and
1430CIK Clean Install Kit
13