Appendix A - Lighting Instructions Plate - Valor H6 Installation Manual

Appendix A - Lighting Instructions Plate

FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING
: If you do not follow these instructions exactly
causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand or by remote control. Follow these instructions exactly. To
save gas, turn the pilot off when not using the appliance for a prolonged period of time.
B. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas
are heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the control knobs. Never use tools. If the knobs will not push in or turn by hand,
don't try to repair them; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system and any gas control, which has been under water.
Fig 1
1. STOP! Read the safety information above
2. TO CLEAR ANY GAS, turn main valve off by pressing the
Wait five (5) minutes to clear out any gas, then smell for gas, including near the floor. If you smell gas,STOP!
follow "B" in the safety information above on this label. If you don't smell gas, go to the next step.
3. AUTOMATIC IGNITION: MAN-knob (2) in ON position. Ensure Flame Adjustment knob (3) is set to lowest
setting (Fig. 1). Locate the pilot (Fig. 3.) inside the firebox.
On the remote control handset, press the
Further short acoustic signals indicate the ignition process is in progress When the pilot is lit,
the Flame Adjustment knob (3) will automatically rotate to the highest setting. Press the
on the remote control handset to reduce the flame height.
4. MANUAL IGNITION: MAN-knob (2) in MAN position (Fig. 2).
With the window off, locate the pilot (Fig. 3) inside the firebox. Set Flame Adjustment
knob (3) to the lowest setting. Push down the metallic core (4) with a pen or
similar instrument; this will establish the pilot gas flow. Light gas at the pilot (5) with a match.
Continue holding down metal core (4) for about 10 seconds; after release, pilot should remain lit.
If the pilot will not stay lit after several tries, turn the gas control knob (3) to OFF and call
your local service technician or gas supplier. Reinstall the window and set the MAN-knob (2) to ON;
turn Flame Adjustment knob (3) up or down manually or use the
remote control handset to adjust the flame height.
AUTOMATIC SHUT-OFF (using the remote control handset):
Press and hold the
Press the button on remote handset to shut-off the appliance, including pilot flame.
70
LIGHTING INSTRUCTIONS
button; a short acoustic signal confirms the start has begun.
TO TURN OFF GAS TO APPLIANCE
button on the remote control handset to shut-off the main burner gas flow.
a fire or explosion may result
Fig 2
button on remote handset (1).
and buttons on the
1
OFF
button
5
Fig 3
Spark
5