Decorative Lighting - Valor H6 Installation Manual

Installation
Lighting
This appliance is equipped with decorative lighting
located above the fuel bed.
Test this overhead lighting before completing
installation—see Appendix B - Remote Control Operation
on page 73. If any of the bulbs are out, replace them
using the following steps.
Required Bulbs
The two light bulbs in the H6 are 120V, 35 W bi-pin (JC)
halogen bulbs GY6.35. Do not install light bulb of more
than 50 W!
Access to Light Bulbs
WARNING
If servicing this fireplace, ensure the
fireplace AND the lighting have been
turned OFF for at least 60 minutes before
you touch them. When in function, both
the fireplace and, independently, the light
bulb receptacles are extremely hot!
Changing the light bulbs requires access to top of the
fi rebox. Remove the barrier screen, side doors and the
fi replace's window. See Window Removal & Reinstallation
on page 37 for details about removing the window.
Light bulbs in shields located on top,
outside of the fi rebox—
Remove window to access them
Wear gloves when changing these bulbs.
Most bulb manufacturers recommend no
skin contact as oil from skin can shorten
the bulbs' lifespan.

Decorative Lighting

Replacing Light Bulbs
We recommend replacing both light bulbs at the same
time.
WARNING
DO NOT access lamps from inside the
firebox!
1. Locate the light shields on top, outside of the fi re-
box.
Shield
securing
clips
Firebox edge
Firebox top
2. To replace the light bulbs:
a. Pull the right, then the left light shield straight
forward, out of the securing clips.
NOTE: If the clips are tight, carefully lift them up
slightly with the blade of a screwdriver.
b. Carefully pull each light bulb out of its receptacle.
c. With a gloved hand, carefully align the new bulb
pins with the receptacle holes and press into
place.
3. Test the lighting with the remote control handset
before reinstalling the shields (lighting can operate
independent of main fi re being on or off ).
4. Reinsert the left, then the right light shield back into
their corresponding securing clips.
NOTE: If you have lifted the clips to remove the
shields, press them back down to secure the shield.
5. Reinstall the window, side doors and barrier screen.
Light shield
63