Remote Control Set-Up - Valor H6 Installation Manual

Installation
Remote Control Initial Pairing
The receiver and the handset of the remote control
system must be initially paired before the fi rst use.
(Note that batteries must already be installed in the
wall mounted battery holder)
1. Insert two 1.5 V AAA alkaline batteries in the hand-
set.
2. Locate the Reset button on the front side of the
receiver.
3. With a thin object, press and hold the receiver's
RESET button until you hear one short and one long
beeps. After the second beep, release the reset but-
ton.
4. Within the subsequent 20 seconds, press and hold
the button on the remote handset for 2-3 sec-
onds. will be displayed on the handset during
the pairing sequence. You will hear two short beeps
confi rming the pairing is done.
If you hear one long beep, the pairing sequence has
failed or the wiring is incorrect.
This is a one time pairing only and is not required when
changing the batteries of the handset or battery holder.
The remote control system is now ready to use.
Install Remote Control Handset Wall Holder
The remote control kit for this fi replace comes complete
with a wall-mounted holder. This holder is not required
in all installations but is provided as an optional feature
for those customers who wish to mount the remote
handset to the wall.
To install the holder to the wall,
fi nd a convenient location and
use the hardware provided with
the kit. Cover the screws with
the included caps to fi nish the
mounting.
Once mounted, the holder is
magnetic - simply place the
remote gently into the holder.
62

Remote Control Set-Up

Radio Frequency
918.0 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
IMPORTANT: The location of the remote control handset
is important to assure proper temperature regulation.
To obtain a constant temperature, we recommend that
the handset should be between 3 and 15 feet away
from the appliance but not directly above it. We also
advise that the handset should be located away from
any other heat source and not in direct sunlight as
this may aff ect the temperature sensor located in the
remote handset.