Install Top Stand-Off And Support Angles; Install Appliance Into Framing; Remove Rear Log Support - Valor H4 Series Installation & Owner's Manual

QUALIFIED
INSTALLER
Install Top Stand-off and Support Angles
The distance from the support angles to the front face
of the heater case is adjustable to allow for a range of
wall fi nish material thickness (e.g. tile, etc.).
1. Check the wall fi nish requirements with the
homeowner.
2. Secure the side support angles from the inside of
the appliance using two screws provided. Set back
the support angles from the front of the appliance
by the thickness of the wall fi nish + 3/4" (19 mm) for
projection.
3. Remove two screws from the rear of the appliance's
frame top.
4. Bend the 12-inch stand-off and fi x it to the appliance
case with the two screws just removed as indicated.
12-inch stand-off supplied fl at

Install Appliance Into Framing

1. Place the appliance in position in the framing.
2. Secure the appliance to the studs.
Note: The support angles screws may be loosened
later from the inside of the appliance to make fi nal
adjustments.

Remove Rear Log Support

Remove the rear log support to access to the rear
orifi ces for restrictors installation (5 screws).
32
Installation
Thickness of wall finish + extra 3/4" (19 mm)
(Appliance MUST project 3/4" (19 mm) in front
of the wall finish surface)
Fit screws
from inside
case
Support angles and stand-off install
Support angles
adjustment
from inside
of the appliance
Support angles fi tting
Remove rear log support
Fix to appliance
case with
two screws