Overview - Valor H6 Installation Manual

Planning
Remote Handset
Wall Holder
Trim with barrier screen
(required)
Fixed Framing Kit 1430FFK
or Clean Install Kit 1430CIK
install at framing stage and
allows non-combustible wall
fi nish to fi nish up to it.
All other trims overlap
the surrounding non-
combustible wall fi nish and
are adjustable to accomodate
material up to 3/4" thickness
overtop of the base 1/2"
non-combustible board. For
material thickness greater
than 3/4", the appliance
requires repositioning further
forward in the framing
cavity—see page 25
Wall Finish.
Any wall fi nishes applied over
non-combustible board must
also be non-combustible.
Combustible mantels are
acceptable provided they
conform to chart on page 11
Electrical Junction Box
location inside appliance case.
NOTE: DO NOT connect if
installing outdoors!
Combustible fl oor
Non-combustible hearth
—see Hearth pages 14-16
1/2" Micore supplied with appliance. Use as a
thermal break between non-combustible hearth
material and combustible material underneath.
WARNING
HOT WALL SURFACES! The wall directly
above the fireplace is constructed of
non-combustible materials and, although
safe, it may reach temperatures in excess
of 200° F (93° C) depending on choice of
trims. Do not touch. Finish the wall using
materials suitable for these temperatures.
10
Note: This appliance may be installed in outdoor, weather protected environments as
defi ned in the GV60CKO Outdoor Conversion Kit instruction manual.
Framing—See pages 13-16
Combustible Framing Allowed Beneath Fireplace.
Do not install the appliance directly on carpet.
HOT HEARTH SURFACES! The heath in
front of the fireplace may become very
hot. Locating the appliance higher than
the surface of hearth and installing the
barrier screen will reduce temperatures.
Note that some materials, although safe,
may deteriorate due to heat—carefully
evaluate which materials to use.
Mantel—See pages 11-12
1/2" thick non-combustible board or
equivalent—NOT supplied—See page 26
Supplied with top facing vent take-off,
field-convertible to rear facing vent take-off
Optional HeatShift System 5" Ø
(4)—See pages 79–98
WARNING

Overview

1400M Fireplace
Remote battery
& Wall switch
(required) 35-
foot wire length)
(supplied)