Overview - Valor H4 650JN Installation Manual

Planning
Remote Handset Wall Holder
Fire ON/OFF Wall Switch
(supplied, recommended)
Wall Finish
May be combustible material.
NOTE: Finished wall surface,
including tiles, etc. MUST be
minimum 3/4" (19 mm) set back
from the front face of the heater.
Surround backing plate required
(sold separately)
Inner front bezel with
barrier screen required
(sold separately)
WARNING
SAFETY WARNING! The H4 is a very effective radiant heater.
HOT WALL SURFACES! The wall directly above the fireplace may be constructed of combustible
materials and, although safe, may become very hot when the fireplace is operating. Do not
touch! Finish the wall directly above the fireplace using materials and methods suitable for
elevated temperatures.
HEARTH/FLOOR SURFACES! The hearth/floor in front of the fireplace can get very hot. Locating
the unit raised above the hearth/floor and using the screen front will help reduce hearth
temperatures. Note that some materials, although safe can degrade due to heat—take this
into consideration when choosing materials.
Note: This appliance may be installed in outdoor, weather protected environments
as defi ned in the GV60CKO Outdoor Conversion Kit instruction manual.
Min. 3/4"
(19 mm)
M i n
c o m
Minimum 1/2" (13 mm) gap required below
backing plate to surface of hearth or fl oor in front
for air fl ow. Raise entire appliance accordingly.
Framing—see page 12
Supplied with top facing vent outlet; can be
converted to rear facing outlet—see page 23
. 1 "
( 2 5
b u
m m
s t i b
) f o
l e m
r
a t e
r i a
l
Hearth (if used) may be
combustible material

Overview

650J Fireplace
Combustible framing
allowed beneath
fi replace. When
the appliance is
installed directly on
carpeting, tile or other
combustible material
other than wood
fl ooring, the appliance
shall be installed on a
metal or wood panel
extending the full
width and depth of the
appliance.
NOTE: Appliance
projects forward of
fi nished wall. Allow for
tile, etc.
11