Overview - Valor LT1 2500KN Installation Manual

Installation Planning
1/2 inch thick non-combustible
board –NOT supplied
Remote
Handset
Wall Holder
Mantel—See Mantel &
Hearth Clearances
S S urrou nd d d Plate l l with i i
Barrier Screen (required)
1" Trim 2575LFB accepts
additional fi nish over non-
combustible board and
behind trim.
2530CIK installs before
non-combustible board.
Non-combustible board
finishes up to perimeter of
t tri tri tri
Wall l ll l l l l l l l F l Fi l l l F Fi i F F F F F n Fi i i ini ni n n
Combustible wall fi n fi nish fi n n ishes nish nish i sh sh s es he
up to 1" thick are allowed owed owed
around perimeter of f f
the fi replace opening.
Combustible mantel are ok
provided they conform to
chart cha cha rt rt on on on pag p g pag pag p g p g p g p g p g p g g g g g g g g g g g g e 1 e e 1 11.
Combustible Floor
WARNING
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel,
and so on because of the heat produced
by the fireplace. Avoid placing candles,
paintings, photos, and other items
sensitive to heat around the fireplace.
10
h h
m. m. m. .
s sh s s h h h h h h h h
e e
ed d ed ed
1. 1.
Hearth: not required.
If used,a combustible hearth must be
minimum 4" below fi replace opening.
Note: This appliance may be installed in
outdoor, weather protected environments as
defi ned in the GV60CKO Outdoor Conversion
Kit instruction manual.
Combustible Framing Allowed Beneath Fireplace. When the appliance
is installed directly on carpeting, tile or other combustible material
other than wood fl ooring, the appliance shall be installed on a metal
or wood panel extending the full width and recessed depth of the
appliance.

Overview

Required HeatShift plenum
(LDK4 pictured)
Required HeatShift piping
Framing—See Framing
Requirements
2500K heater
Remote Battery
and Wall Switch
Kit c/w 35-foot wire
length (supplied)
Electrical junction
box to connect
power when
using lighting or
optional WiFi