Overview - Valor 2700KN Installation Manual

Installation Planning
1/2 inch thick non-combustible
board –NOT supplied
Remote
Handset
Wall Holder
Mantel—See Mantel &
Hearth Clearances
Surround Plate with w
Barrier Screen (require e d) e
1" Trim 2775LFB accepts
additional fi nish (maximum u
1/2" thick) over no o n- o
combustible board a a nd a
behind trim. r
2730CIK installs befo o re o
non-combustible boa a rd. a
Combustible or no o n- o
combustible board finish h es h
up to perimeter of trim. r
W W Wall W W Wa l Wa W al l l l l Fi i Fi Finis F F F i n ini i i ni h h n i sh s sh
Combust bust b b b b bust ustible wall fi nishes us st i l e e w w all ll fi fi a a a fi n n h h e is e is he s s es
up to o 1" t o 1" t t o 1" thick are allowed o 1" t " hi t ck th k a h c a a a r re a a a a l o lo o e we w d d we ed
over over top over top of the non- r top p r top to o op of f p p th t no h h e h h e n n on n on
combus bustible board. bustibl tibl tibl ible e e b b o o oa a rd d
Combustible mante ntel ar nte are ok l are ok k l are a r o e e ok k
provided they conform orm to orm to m to m to o o o t
cha cha chart rt rt on on on p g pag p g p g pag p g p g p g pag p g g g g g g g g g g g g e 1 e 1 e 11.
Combustible Floor
Hearth: not required.
If used,a combustible hearth must be
minimum 4" below fi replace opening.
WARNING
Some materials or items, although safe,
may discolor, shrink, warp, crack, peel, and
so on because of the heat produced by the
fireplace. Avoid placing candles, paintings,
photos, and other items sensitive to heat
around the fireplace.
10
h h h h h
k
1 1 1. 1.
Note: This appliance may be installed in
outdoor, weather protected environments as
defi ned in the GV60CKO Outdoor Conversion
Kit instruction manual.
Combustible Framing Allowed Beneath Fireplace. When the appliance
is installed directly on carpeting, tile or other combustible material
other than wood fl ooring, the appliance shall be installed on a metal
or wood panel extending the full width and recessed depth of the
appliance.

Overview

Required HeatShift plenum
(LDK4 pictured)
Required HeatShift piping
Framing—See Framing
Requirements
2700K heater
Remote Battery
and Wall Switch
Kit c/w 35-foot wire
length (supplied)
Electrical junction
box to connect
power when
using lighting or
optional WiFi