Connecting The Handle - Minelab F3 COMPACT Service Manual

_______________________________________________________________________________________________________________________

3.6.2 Connecting the Handle

a. To connect the handle the detector body must be opened as described in Section
Opening the Detector
Thread the wiring loom handle into the detector body. Figure 83.
•
Push the handle onto the pin handle pivot. Figure 83.
•
Connect the spring latch hinge to the latch hinge. Figure 84.
•
Feed the rod handle slide through the handle and into position.
•
Rod passing through Armrest Slide
Connect the wiring loom handle and fit into the cable router. Figure 85.
•
Body. Once completed:
Pin Handle Pivot
Figure 83: Threading the Wiring Loom
and Handle
Figure 84: Latch Hinge and Spring Latch Hinge
51
F3 COMPACT Service Manual
Spring
3.1 -
Latch