Minelab F3 COMPACT Service Manual page 23

_______________________________________________________________________________________________________________________
Attach the hinge cover and make sure the protrusion on the underside of the hinge cover
•
engages into the slot on the detector body near the hinge. Fit the two (2) screws (45mm)
into the hinge cover and tighten. Figure 27.
Reattach the armrest with four (4) screws (12mm). Figure 28.
•
Check all moving parts for correct operation.
•
Insert batteries, turn on the detector then conduct mechanical & functional testing as
•
described in Section 2
•
•
•
•
•
•
•
Figure 27: Fitting Hinge Cover
Figure 28: Attaching the Armrest
Mechanical & Functional Testing.
23
F3 COMPACT Service Manual