Minelab F3 COMPACT Service Manual page 38

F3 COMPACT Service Manual
_______________________________________________________________________________________________________________________
The two (2) screws can be used to adjust the friction of the coil pivot movement.
Push the pin coil pivot out with a pin punch or hex key driver and remove the pin coil
•
pivot. Figure 57.
Separate the pivot lower shaft from the pivot coil yoke. Gently feed the coil cable
•
through the pivot lower shaft removing the pivot shaft from the coil cable. Do not stretch
the coil cable. Figure 58.
Pivot Coil Yoke
Pull the pivot coil yoke off the coil and carefully thread the coil cable through the pivot
•
coil yoke. If required remove the O-ring from the coil. Figure 59.
Figure 56: Removing two (2) Screws
Figure 57: Removing Pin Coil Pivot
Figure 58: Removing Pivot Lower Shaft
NOTE
Pivot Lower Shaft
38