Minelab F3 COMPACT Service Manual page 17

_______________________________________________________________________________________________________________________
Using fingers gently separate the left and right body halves. The battery end of the
•
detector will come away easily. The shaft end is held by two (2) locating pins and will
require more force to separate.
Gently lift the right side off the left body half taking care not to pull or stretch the speaker
•
cable and connector. Figure 14.
Locate the speaker connector on the interface PCB and disconnect the speaker from the
•
interface PCB (Figure 14). Remove the right half of the detector body.
Remove the upper shaft from the detector body taking care not to snag and damage the
•
coil cable and plug. Figure 15.
Interface PCB
Figure 14: Disconnecting Speaker Connector
Figure 15: Removing Shafts
17
F3 COMPACT Service Manual
Speaker Connector