Minelab F3 COMPACT Service Manual page 47

_______________________________________________________________________________________________________________________
Lift the shafts clear of the detector.
•
Remove the pin coil cable from the upper end of the upper shaft. Turn the pin coil cable
•
clock wise and then lift out.
Remove the two (2) nylon screws from the cap shaft on the lower shaft as indicated in
•
Figure 76.
Insert a flat tip screwdriver into the slot underneath the cap shaft and lift and remove the
•
cap shaft.
Slide the coil out and off the lower shaft, exposing the coil cable. Feed the coil cable
•
connector into the upper shaft and pull the coil cable out of the end of the lower shaft.
Figure 77.
Figure 74: Shaft and Coil Removed from Detector
Figure 75: Removing Pin Coil Cable
Figure 76: Removing Screws from Lower Shaft
47
F3 COMPACT Service Manual