Attaching The Shafts; Handle - Minelab F3 COMPACT Service Manual

F3 COMPACT Service Manual
_______________________________________________________________________________________________________________________
b. The Shafts have now been removed from the F3 COMPACT.

3.5.3 Attaching the Shafts

a. The detector body needs to be opened in order to fit the shafts to the detector, refer to
Section 3.1 – Opening the Detector
b. The coil must be connected to the shaft then the shaft connected to the detector this
process is described in Section
c. Assemble the detector as described in Section
d. Once the detector is fully assembled check the operation of all moving parts and test the
detector as described in Section

3.6 Handle

a. The Handle kit 3004-0050 is a line replaceable unit and Figure 79 illustrates the major
parts of the handle.
Figure 77: Removing Coil Cable from Shafts
Figure 78: Detector Shaft and Coil
Body.
3.4.6 - Connecting the
2 - Mechanical & Functional
Coil.
3.2 - Closing the Detector
48
Body.
Testing.