Minelab F3 COMPACT Service Manual page 32

F3 COMPACT Service Manual
_______________________________________________________________________________________________________________________
Make sure all connectors are firmly in place and all wires and cables are positioned so
•
that they will not cause obstruction or get damaged when the two halves of the main
body are fitted together.
Insert the two (2) screws (12mm) to the interface PCB. Figure 46.
•
Connect the nut (18mm) to the coil connector and tighten. Figure 46.
•
b. Finish assembling the detector by closing the detector body, as described in
Closing the Detector Body
Figure 46: Interface PCB and Coil Connector Nut
32
Section 3.2 –