Minelab F3 COMPACT Service Manual page 31

_______________________________________________________________________________________________________________________
Lay the cable 10 way under the interface PCB. Take note of the connector key tab that
•
aligns with the slot in the interface PCB. Figure 43.
Gently align and connect the connector 10 way. Figure 43.
•
Align the cable 6 way ribbon with its connector. Slide the connector locking bail outwards
•
to accept the cable 6 way ribbon. Figure 44.
Insert the cable 6 way ribbon into the connector then push the locking bail in to secure.
•
1. Pull locking bail out to accept Cable
2. Insert 6 Way Ribbon Cable
Connect the battery connector to the main PCB. Figure 45.
•
Figure 43: Connector 10 Way
Figure 44: Connecting Six Way Ribbon Cable
Figure 45: Connecting Battery Connector
31
F3 COMPACT Service Manual
Alignment Key
3. Push locking bail