Minelab F3 COMPACT Service Manual page 22

F3 COMPACT Service Manual
_______________________________________________________________________________________________________________________
Torx symbol
marks location of
all Torx Screws
Check the detector assembly and test all moving parts.
•
Place the detector on its right side. Remove the hinge cover then insert and tighten the
•
two (2) screws (35mm) into the shaft hinge. Figure 25.
Confirm coil connector is tight and check the coil cable and the wiring loom are located
•
into the cable router. Figure 26.
Check the latch h and spring latch hinge are connected as shown in Figure 26. If the latch
•
hinge and spring have become disconnected they must be reconnected.
Cables held in
Cable Router
O-ring
Figure 24: Inserting Torx Screws.
Figure 25: Fitting Screws into the Shaft Hinge
Figure 26: Underneath Hinge Cover
Spring Latch
Spring Eyelet
located on pin of
Latch Hinge
22
Hinge