Attaching The Coil Pivot - Minelab F3 COMPACT Service Manual

_______________________________________________________________________________________________________________________
O-Ring

3.4.5 Attaching the Coil Pivot

a. To attach the coil pivot, firstly remove the coil from the detector as described in section
3.4.2 - Removing the
Attach the O-ring to the coil as shown in Figure 60.
•
O-Ring
Five 5 Coils
inside Pivot
Identify the section of coil cable closest to the coil and wind or unwind the coil cable to
•
achieve five (5) turns. The five (5) turns of cable will be located within the pivot with the
pin coil pivot passing through the centre. Figure 60.
Feed the pivot coil yoke onto the coil cable and carefully move the pivot coil yoke along
•
the coil cable to the coil. Align and then push the pivot coil yoke into place on the coil.
Check the pivot coil yoke rotates through 90 degrees with end stops. Figure 61.
Figure 59: Removing Pivot Coil Yoke
Coil. Once completed:
Figure 60: O-Ring and Coil Cable
39
F3 COMPACT Service Manual