Minelab F3 COMPACT Service Manual page 43

_______________________________________________________________________________________________________________________
Fit the cover shaft hinge to the shaft and screw into place. Figure 67.
•
Slide the coil into the end of the lower shaft. Fit the cap shaft then fit the two (2) screws
•
(14mm Nylon) as shown in Figure 68.
Thread the coil cable through the detector hinge and attach the shaft onto the detector
•
hinge.
Connect the coil connector (Figure 70) and close the detector body described in Section
•
3.2 - Closing the Detector
Figure 67: Fitting Pin Coil Cable and Cover Shaft Hinge
Figure 68: Connecting Coil to Lower Shaft
Figure 69: Connecting Shaft and Coil
Body.
Cap Shaft
43
F3 COMPACT Service Manual