Minelab F3 COMPACT Service Manual page 40

F3 COMPACT Service Manual
_______________________________________________________________________________________________________________________
Feed the pivot shaft onto the coil cable. Align the coil cable with the 5 turns of cable
•
inside the pivot then press the pivot shaft onto the pivot coil yoke. Ensure the coil cable
retains the 5 turns of cable within the pivot. Figure 62.
Push the pin coil pivot into the pivot coil yoke. The pin must travel up the centre of the 5
•
turns of coil cable inside the pivot. If there is resistance to inserting the pin open the
pivot and try again. Do Not Use Excessive Force. Push the pin in with fingers and click
into place. Figure 63.
The pin coil yoke must thread through 5 turns of the cable inside the pivot.
Check the movement of the pivot in both directions.
•
Figure 61: Fitting Pivot Coil Yoke
Figure 62: Fitting Pivot Lower Shaft
Figure 63: Inserting Pin Coil Pivot
NOTE
40