Minelab F3 COMPACT Service Manual page 35

_______________________________________________________________________________________________________________________
Unscrew and disconnect the coil connector. Figure 50.
•
Remove the pin coil cable from the upper end of the upper shaft. Turn the pin clockwise
•
then pull to remove. Figure 51.
Remove the two (2) screws (Nylon 14mm) from the cap shaft on the lower shaft as
•
indicated in Figure 52.
Coil
Connector
Figure 49: Removing Hinge Cover
Figure 50: Disconnecting Coil Connector
Figure 51: Removing Pin Coil Cable
Figure 52: Removing Screws from Lower Shaft
35
F3 COMPACT Service Manual