Replacement Of The Distribution Annular Oil Seal - Dacia 1304 2004 Repair Manual

ENGINE AND LOWER ENGINE UNITS

REPLACEMENT OF THE DISTRIBUTION ANNULAR OIL SEAL

D
ISMOUNTING
Disconnect the battery.
Place the no.1 cylinder at the dead point in
orde to avoid the falling of the key from the
crankshaft when disounting the crankshaft pul-
ley .
Dismo unt :
- engine shield;
- alternator belt;
- crankshaft pulley.
Dismount the old annular oil seal by means of
the MOT 457 A device.
R
EMOUNTING
Mount the new annular oil seal on the mount-
ing chuck of the MOT 457 A device.
Lubricate the outside of the annular oil seal
with oil and place it on the cap.
Tighten the nut until the chuck comes into
contact with the cap.
Mount:
- the crankshaft pulley after the
surface between the pulley hub and the
distributtion pinion has been lubricated with
.
LOCTITE 518
Mount the alternator belt and adjust its
tightness.
10 - 55
10