Unscrew :
- the attachment nuts (1)and (2) of the
casing on the longitudinal girder;
- the nuts (3) of the stabilizer rod aux-
iliary connecting rod.
Dismount the stabilizer rod together with
the auxiliary connecting rod.
Check the state of the elastic bushings; if
it shows marks of wear, replace the
auxilia ry connecting rod.
Mount the auxiliary connecting rods on the stabilizer rod.
Grease the auxiliary connecting rod shaft with special MoS2 grease.
Mount the assembled stabilizer rod.
Press the front axle at a distance D = 45 mm by means of the TAV 238 – 02 device.
Tighten at the required moment:
- casing attach ment nut;
- auxiliary connecting rods shaft nuts;
- the nuts that attach the auxiliary connecting rod to the stabilizer rod.
FRONT BEARING ELEMENTS
FRONT STABILIZER ROD
D
ISMOUNTING
R
EMOUNTING
31 - 33
31