Electronic Keys Programming Procedure - Dacia 1304 2004 Repair Manual

82

ELECTRONIC KEYS PROGRAMMING PROCEDURE

ELECTRONIC KEYS PROGRAMMING PROCEDURE
This is to be applied when the replacement of the electronic keys is needed and the procedure is
as follows:
- bring the switch (1) of the UCE anti starting in position "ON";
- place the end of the first electronic key in contact with the anti starting receiver;
- after one second, place the end of the second electronic key in contact with the anti starting
receiver;
- bring the switch (1) of the anti starting UCE to the position "OFF";
- check using both electronic keys the good operation of the anti starting.
These operations must be performed only when the UCE anti starting is not in stand
by state.
The maximum number of electronic keys which can be re-programmed for a vehicle
is maximum 4; so, if the two original electronic keys of the vehicles have been lost or
have been defected, only maximum two other electronic keys may be re-programmed.
HORN - ENGINE IMMOBILISER
ATTENTION !
82 - 4