Clutch Disk-Mechanism - Dacia 1304 2004 Repair Manual

CLUTCH DISMOUNTING - REMOUNTING
D
ISMOUNTING
Dismount the gearbox. from the vehicle.
ATTENTION!
For the injection engines, before gearbox
dismounting from the vehicle, dismount the
RPM transducer in order to avoid its
damaging.
Unscrew the clutch mechanism attachment
screws and dismount the clutch.
Check the state of the component parts and
replace the used or defective ones.
R
EMOUNTING
Degrease the flywheel friction surface.
Place the clutch disk with the damping
flange towards the gearbox.
Center the clutch disk by means of the
AMB 319 mandrel (for z = 20) or by means
of the AMB 320 mandrel (for z = 21).
Place the mechanism and center it on the
centering shafts.
Progressively tighten the screws then
tighten them at the required moment :
- M7 : 1 -1,2 daNm;
- M8 : 1,5 - 2 daNm.
Slightly grease the diaphragm with grease
UM170 Li Ca Pb 2M ,on the area where it
comes into contact wi t h the pressure bearing.
Remount the gearbox. on the vehicle.
Adjust the clutch stroke (2,5 - 3,5 mm at
the end of control lever).
CLUTCH
CLUTCH DISK – MECHANISM
20 - 3
20