Rear Longitudinal Girder (Dacia 1304) - Dacia 1304 2004 Repair Manual

REAR LONGITUDINAL GIRDER ( Dacia 1304 )
This operation shall be performed only on the repair bench. For the specific supports
mounting on the bench, please see the 40 chapter.
D
ISMOUNTING
Dismount the elements, which are in
contact with the rear longitudinal girder.
Detach the welding points of the rear
longitudinal girder (1) which are in con-
tact with:
- the front cross bar in the area (2);
- the inner frame in the areas (4),(5),(6);
- the rear end cross bar in the area (3);
- the middle cross bar in the area (9);
- the spare wheel cross bar in the area (8);
- the central cross bar in the area (10);
- the rear floor in the area (3).
Straighten the areas resulted by
dismounting.
Grind the areas resulted by dismounting.
R
EMOUNTING
Position and center the new element.
Check the correct positioning of the rear
longitudinal girder.
Weld the rear longitudinal girder (1)
after the ass embling
2,3,4,5,6,7,8,9,10.
Perform two C0 2 welding layers in the
connecting area of the rear longitudinal
girder with the front cross bar, central,
middle and the spare wheel cross bar.
Protect the new element with a corrosion
preventing and noise absorbent product.
LOWER STRUCTURE
REPLACEMENT
1
2
3
SECO
2cordon X 40mm
SECO
2cordon X 45mm
Middle cross member
outliners
SECO
2cordon X 20mm
1cordon X 40mm
SECO
2cordon
X 45mm
41 - 5
10 9 8
4
Rear longitudinal girder
Spare wheel cross bar
2
2
Rear longitudinal girder
2
2
Central cross member
41
7
5 6
Front cross
member
Rear longitudinal
girder
Rear longitudinal
girder