Rear Door Window Regulator - Dacia 1304 2004 Repair Manual

SIDE OPENING ELEMENTS MECHANISMS
D
ISMOUNTING
In order to dismount a door window and the
window regulator of the back door
window, perform the following operations:
Remove the screws (11) and (12).
Using the technological opening (14) in the
inner side of the door , remove the elastic
washer and the safety washer (20), which
make the connection with the window slide-bar,
by slightly sliding it to the lower part.
Remove the three screws (15),releasing the
back window regulator (19) and remove it
from the inner door.
For remounting , the operations shall be performed in the reverse order :
Replace the channel support in the rear inner side of the door , place the assembly
inside the door frame, then remove again the frame , to allow the placing of the window in
the channel support.
Replace the window regulator mechanism (19) and temporally attach its sealing washer
(R).
The window placed in the channel support shall be secured by means of the safety
gasket and the washer (20) and the lateral frame from the window attachment (21) shall be
temporally attached by means of the screws (11) and (12), using the technological opening
(22) ; test rolling up the window several times , after which completely tighten the screws.

REAR DOOR WINDOW REGULATOR

R
EMOUNTING
51 - 5
51