Speedometer Endless Screw Pinion Replacement - Dacia 1304 2004 Repair Manual

SPEEDOMETER ENDLESS SCREW PINION REPLACEMENT

D
ISMOUNTING
Lift the car on the elevator
Drain the oil from the gearbox.
Disconn ect:
- the speedometer cable;
- the velocity steps control.
Disconnect the cardan transmission and
dismount the secondary shaft flange
(G.B.50C;51).
Dismount the back crossbar.
Dismount the back cap.
Dismount the speedometer endless pinion
from the back cap.
Replace the speedometer endless
(G.B.50C,51C).
Engage velocity step I and draw the hand
brake.
Dismount the speedometer endless screw
by means of the CV 204 wrench.
MANUAL GEARBOX
(on vehicle )
R
Mount the speedometer new endless
screw by means of the wrench CV 204
and tighten at the required moment
(10-12 daNm) and secure it by straining.
(G.B. 365).
the back cap.
Before mounting, the speedometer
pinion shall be immersed in 80W/90.
Mount the back cap with a new gasket.
Mount the back crossbar.
Connect:
Mount the flange, tighten its nut at the
required moment (10 - 12daNm) and connect
card an tran smi s sio n (G.B.50C,51C).
Check the velocity steps control.
Fill up the gearbox with 80W90 oil.
21 - 47
EMOUNTING
Mount the new speedometer pinion in
NOTE:
- the speedometer cable;
- the velocity steps control.
21