Windows - Dacia 1304 2004 Repair Manual

WINDSCREEN AND CAB REAR WINDOW
The replacement of these windows is performed in case they are broken, when they are
not according to the required overall dimensions or have manufacturing defects (image
distortions,cracks, etc).
DISMOUNTING OF A BROKEN WINDOW
If the window or part of it did not fall, the window gasket shall be dismounted and the
pieces of broken window shall be removed from it easier by sticking a sheet of paper on
each surface.
Position the gasket (2) around the
window (1) and place the assembly on a
protection plate.
Place in the gasket channel all around
the gasket frame; a cotton cord (4) of
3 – 4 mm diameter, so that at its ends (3)
to have some more 20 cm of cord, and
between the ends , the distance shall not
be more than 10 cm.
MOUNTING OF WINDSCREEN AND REAR WINDOW
The windscreen – gasket – cord assembly
is placed on the frame, for mounting, so
that the cord ends are placed towards the
inside of carriage body.
From the inside of the vehicle, successively draw the ends of the cord, beginning with
the lower parts, in this way the window gasket edge is lifted and then lowered on the
frame. At the outside , the window gasket is seated by slightly pressing it on window, so
that the tightening is uniform on the whole windscreen contour and frame.
The cord is always removed through the upper part of the windscreen.
Each time a windscreen or rear window is mounted, ensure the uniform setting of the
whole assembly on the carriage body by tapping several times with a rubber hammer, on
the edge of the window frame.

WINDOWS

WINDOWS
PREPARING FOR MOUNTING
54 - 1
1
2
3
54
4