- Brake caliper fork attachment screw on steering knuckle................ 6,5 daNm
- Disk attachment screw on the hub..................................................... 2 daNm
- Steering knuckle front wheel nut....................................................... 23 daNm
- Wheel nut............................................................................................ 9 daNm
The brake disk shall be not rectified.
A bigger wear or important marks on the brake disk impose obligatory replacement of
the brake disk.
The minimal accepted thickness of not aerate disk .......................................9 mm
The minimal accepted thickness of aerate disk.. .........................................19 mm
The maximum accepted axial deviation ...................... 0,2 mm on diameter φ φ φ φ 215
The maximum axial deviation is 0,2 mm. If the thickness of the disk is smaller than
9 mm or if the wear is not uniform, the disk shall be replaced.
FRONT BEARING ELEMENTS
BRAKE DISK
FRONT BRAKE DISK
:
SPECIAL TOOLS
D
ENOMINATION
Caliper piston pusher
Dynamometric wrench
T
IGHTENING MOMENTS
NOTE:
C
ODE
FR 500
MOT 30
31 - 17
31