Install An Acx7100-32C Router In A Rack - Juniper ACX7100-32C Hardware Manual

• Phillips(+) screwdriver, number 1 and number 2, for the mounting screws (not provided)
• Two power cords with plugs appropriate for your geographical location (provided)
• RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided)
• Management host, such as a PC laptop, with a serial port (not provided)
CAUTION: If you are mounting multiple units on a rack, mount the heaviest unit at the
bottom of the rack and mount the other units from the bottom of the rack to the top in
decreasing order of the weight of the units.

Install an ACX7100-32C Router in a Rack

To install the router in a four-post rack:
1. Position the router in front of the rack.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the
other end of the strap to a site ESD point.
3. Align the holes in the front-mounting rails with the holes on the side of the chassis (see
on page 63).
Figure 21: Install the Mounting Rails on an ACX7100-32C Router
4. Using a Phillips (+) number 1 screwdriver, secure the mounting rails to the chassis using the
mounting screws.
5. With one person on each side, hold on to the bottom of the chassis, and carefully lift the chassis so
that the mounting rails are aligned with the rack rails.
63
Figure 21